Trendy Fringe (HD)

Hair Pieces Collection by HairDo
Heat-Friendly Clip In Bangs

Fiber Type:  Tru2Life® Heat-Friendly Synthetic
Application Method:  Three Pressure Sensitive Clips

Length:  Bangs 6" • Side 10 3/4" • Back 10 3/4"

Weight:  1 oz

Color Shown:  R1416T Buttered Toast • R14/88H Golden Wheat 

This clip-in bang changes up your entire look! It’s also an instant fix for concealing outgrown roots, forehead wrinkles and thinning hair at the temples or along the front hairline. The exclusive Tru2Life® heat-friendly synthetic lets you flat iron super straight or use a curling iron to create a soft bend. The best part? It’s commitment-free hair fashion. Bangs today, gone tomorrow.

Made with Tru2Life® heat-friendly synthetic hair that can be flat-ironed, curled or blown out. (See packaging insert for complete directions.)

HOW-TO

PRE-WASH

Gently remove tangles with fingers or a wide-tooth comb. Start at the ends and slowly work toward the roots to avoid damage. Do not brush.

WASH/ CONDITION

Add a small amount of HairUWear Shampoo to a washbasin of cool water. Use shampoo sparingly.

Place product in washbasin and allow it to soak for 5 minutes. Do not scrunch or agitate the product.

Rinse by holding under running cool water until the water runs clear. Gently squeeze or use a clean, dry towel to press out excess water. Do not twist or wring.

Apply a light coat of HairUWear Leave-in Conditioner + Detangler avoiding the base and roots. Applying conditioner to the base may cause shedding.

Place wet hair piece on a HairUWear Hanger until it is completely dry. finger styling is recommended.

STYLING

Shake and style with your fingers to achieve the desired look. We recommend a HairUWear Styling Brush, HairUWear Styling Comb or fingers to style.

Apply a light mist of HairUWear Leave-in Conditioner + Detangler to difficult tangles if needed.

True2life ™ Heat-friendly synthetic fiber can be curled, blow dried or flat ironed to achieve a different hairstyle.

True2life™ Heat-friendly synthetic fiber can withstand heat up to 350°F/180°C. We recommend a low-medium setting

To straighten, take a 1 inch section starting at the roots and run a flat iron to the ends.

To curl, wrap the hair around a curling iron and hold for 10 seconds.

Carefully slide the iron out and pin the curl in place.

Once the fiber has completely cooled it will keep the curl until heat is applied again.

If desired, use HairUWear Hair Spray on the final styled product.

TIPS & TRICKS

Soaking longer than the recommended time will damage the product.

Hot water will damage Excelle™ heat-friendly synthetic fiber.

Sudden bursts of heat, such as opening an oven door, will damage heat-friendly synthetic fiber.

We do not recommend sleeping, showering or swimming during wear.

Store hair piece on a HairUWear Hanger to avoid unwanted kinks or crimps

After extended wear, matting and frizz can occur. To smooth, wash, condition and spray with HairUWear Leave-in Conditioner + Detangler then blow dry with a HairUWear Styling Brush.

Fiber will be damaged if the heat setting is too high. We do not recommend curling or straightening the hair while wearing. True2life ™ Heat-friendly synthetic fiber will get very hot.

Any cutting should be done by a professional hair stylist.

20220101